2.5.4.7 Pause Insertion
Description
Pressing a PAUSE button inserts a preprogrammed Pause time between digits of a user-dialled number before
the number is dialled out, allowing certain numbers separated with a pause to be used to access certain
features (e.g., access codes, seizing idles lines, etc.).
When a pause is needed, pauses must be inserted manually (pressing the PAUSE button) in all cases, except
for the following access codes where a pause is automatically inserted between the user-dialled access code
and the subsequent digits:
a. Host PBX Access code (® 2.5.4.8 Host PBX Access Code (Access Code to the Telephone Company
from a Host PBX))
b. Special Carrier Access code (® 2.5.4.9 Special Carrier Access Code)
c. Second Dial Tone Waiting code
Conditions
• The Pause time is programmable for each trunk.
• Pauses can be stored in Memory Dialling.
• When a Second Dial Tone Waiting code is dialled after seizing a trunk, a preprogrammed number of pauses
are inserted after the code.
• ARS
A pause is not automatically inserted between the user-dialled access code and the subsequent digits
when the ARS mode is enabled. (2.8.1 Automatic Route Selection (ARS))
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port—
Pause Time
10.3
PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—
During Conversation—
Pause
Signal Time (s)
14.4 PBX Configuration—[6-4] Feature—Second Dial Tone
PT Programming Manual References
[416] LCOT Pause Time
Feature Guide 111
2.5.4 Trunk Call Features
To Next Page
Loading...
Need help?
General
