Panasonic KX-NS500 Features Guide

5.5.6 Dynamic Host Configuration Protocol (DHCP) Server
Description
The
PBX has a built-in DHCP server. When the DHCP server is enabled, the PBX will automatically assign IP
addresses to other devices on the network, such as IP-PTs.
Using a DHCP server simplifies network management by removing the need to assign IP addresses to devices
manually.
Conditions
• The DHCP Server feature cannot be used if the PBX’s IP address assignment mode is set to DHCP.
• If the PBX’s DHCP server is enabled, make sure that no other DHCP servers are running on the same
network. Having more than one DHCP server on a network can result in network errors.
• For the following settings, the PBX delivers the settings of its LAN port to devices: subnet mask, default
gateway address, and DNS server addresses. As NTP server information for KX-UT extensions, the PBX
delivers its own IP address.
PC Programming Manual References
27.2.1 Network Service—[2-1] Server Feature—DHCP
Feature Guide 541
5.5.6 Dynamic Host Configuration Protocol (DHCP) Server

Panasonic KX-NS500 Specifications

General

Analog Extensions	Up to 64
VoIP Support	Yes
System Type	Hybrid IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Maximum Extensions	288
IP Extensions	128
VoIP Channels	64
SIP Trunks	64
Networking	Yes, supports networking
Built-in Applications	Call Center
Expandability	Yes, via expansion cards and cabinets
Supported Protocols	SIP, H.323, MGCP
Dimensions	430 x 88 x 367 mm