2.24.3.3 Walking Extension-Home position control
Description
The Walking Extension and Enhanced Walking Extension features include the Home position control feature
which can be set through system programming.
The Enable/Disable setting for Home position control applies to both the Walking Extension and Enhanced
Walking Extension features.
Disable: Location Switch
The location of the extensions are switched.
Enable: Return to the home location
When the location of the extensions are switched via Walking Extension or Enhanced Walking Extension, they
are returned to their original locations (home locations).
When performing Walking Extension with this feature enabled, if you want to move your location permanently,
you must return your extension to its home location before moving.
When performing Enhanced Walking Extension with this feature enabled, the extension will return to its home
location when the status is changed to Service-out mode.
[Example]
Service-out Service-in
<Disable: Location Switch>
Extn. 101 Extn. 102 Extn. 102
Location 1
Service-out Extn. 101 Service-inExtn. 101 Service-in Extn. 101 Service-out
Extn. 102 Extn. 101 Extn. 101
Location 2
Explanation:
When
an extension user enters Service-in mode at a location other than the home location, the location of the
extensions are switched.
This can be confusing for the user of the switched extension because the location of his/her extension may be
unknown.
288 Feature Guide
2.24.3 Walking Extension Features
To Next Page
Loading...
Need help?
General
