Panasonic KX-NS500 Features Guide

2.1.1.7 Intercept Routing—No Destination
Description
Provides automatic redirection of incoming trunk calls that do not have a destination assigned. The intercept
destination is an operator (tenant/PBX).
Conditions
• Intercept Routing—No Destination on/off
The Intercept Routing—No Destination feature can be enabled or disabled through system programming.
If disabled, a reorder tone will be sent to the caller. However, the Intercept Routing—No Destination feature
always functions for calls through the LCOT card even when disabled.
• If an operator (tenant/PBX) is not assigned:
The extension that is connected to the lowest-numbered port and is ready to receive calls will be the
intercept destination.
• Intercept Routing—No Destination also applies to calls from doorphones.
PC Programming Manual References
10.2 PBX Configuration—[2-2] System—Operator & BGM—
PBX Operator—Day, Lunch, Break, Night
18.5 PBX Configuration
—[10-5] CO & Incoming Call—Miscellaneous—
Intercept—Routing to Operator -
No Destination (Destination is not programmed.)
PT Programming Manual References
[006] Operator Assignment
Feature Guide References
5.1.5 Operator Features
38 Feature Guide
2.1.1 Incoming Trunk Call Features

Panasonic KX-NS500 Specifications

General

Analog Extensions	Up to 64
VoIP Support	Yes
System Type	Hybrid IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Maximum Extensions	288
IP Extensions	128
VoIP Channels	64
SIP Trunks	64
Networking	Yes, supports networking
Built-in Applications	Call Center
Expandability	Yes, via expansion cards and cabinets
Supported Protocols	SIP, H.323, MGCP
Dimensions	430 x 88 x 367 mm