PerkinElmer CLARUS 680 GC User Manual

Clarus 600/680 GC User’s Guide
7-11
Detector Settings
Flame Ionization Detector (FID)
1. Touch the FID button
on the Status Screen.
2. To program the temperature in the FID tab touch the Temperature field and
it will turn black. Then use the up and down arrow or keypad
buttons to set to the required temperature for your application.
3. Set the Atten (attenuation) and Range by touching the arrow button
and selecting a value from the drop-down list as shown in the example
below. This example also shows that the Heater is off.
4. If you require the heater on for your analysis just touch the Heater button
and it will toggle to heater on.

PerkinElmer CLARUS 680 GC Specifications

General

Brand	PerkinElmer
Model	CLARUS 680 GC
Category	Laboratory Equipment
Language	English