PerkinElmer CLARUS 680 GC User Manual

Clarus 600/680 User’s Guide
3-19
Setting Up a One-Ramp Injector Program
To set up a one-ramp injector program, enter the following parameters:
• Initial injector temperature (Init Temp)
• Isothermal time for the initial temperature (Init Time)
• Rate of temperature increase from the initial to the final injector temperature (Init
Rate)
• Final injector temperature (Temp 2)
• Isothermal time for the final temperature (Time 2)
• Temperature increase of 0
°C/min, which signifies the end of the Rate 2 step.
The following example shows how to build a one-ramp temperature program for your
POC or PSS injector. The parameter values used in the example are shown below:
Parameter
Value
Init Temp 60 °C
Init Time 0 min
Init Rate
100 °C/min
Inj Temp 2
250 °C
Inj Time 2 15 min
Inj Rate 2
End (0°C/min)
To set up a one-ramp injector program:
1. From injector tab screen touch the temp program button
.

PerkinElmer CLARUS 680 GC Specifications

General

Brand	PerkinElmer
Model	CLARUS 680 GC
Category	Laboratory Equipment
Language	English