Installing Options
17
2
F
After installing the option, print the configuration page to confirm the installation.
Note
❒ When moving the printer, remove the optional paper feed unit.
❒ Before using the optional paper feed unit, you can make settings in the
printer driver.
❒ If the new device is listed in the column of configuration options, then it
has been properly installed.
❒ If the optional paper feed unit is not installed properly, reinstall it follow-
ing this procedure. If you cannot install it properly even after attempting
reinstallation, contact your sales or service representative.
Reference
For details about printing the configuration page using control panel, see
p.14 “Test Printing”.
For details about loading paper into the paper tray, see p.45 “Loading Pa-
per”.
When adjusting the printing position, see Software Guide.
Attaching Memory Unit Type F 256MB (DDR-SDRAM Module)
CAUTION:
Important
❒ Before touching the memory unit, ground yourself by touching something
metal to discharge any static electricity. Static electricity can damage the
memory unit.
❒ Do not subject the memory unit to physical shocks.
A Turn off the power, and then unplug the power cable.
B Remove the memory cover.
• Before installing the memory unit, turn off the printer's power switch and un-
plug the power cable. After installing the memory unit, be sure to close the
memory unit cover, and then turn the machine back on. Do not turn on the
machine before closing the memory unit cover.
ASI080S
To Next Page
Loading...
Need help?
Printing
Paper Handling
Power
Weight and Dimensions
