Rockwell Automation Publication 2198-UM001D-EN-P - May 2014 99
Chapter 6
Configure and Start the
Kinetix 5500 Drive System
This chapter provides procedures for configuring your Kinetix 5500 drive system
with a Logix5000 controller.
Topic Page
Understanding the Kinetix 5500 Display 100
Configure the Drive 104
Configure the Logix Designer Application Project 105
Apply Power to the Kinetix 5500 Drive 129
Test and Tune the Axes 131
Understanding Bus Sharing Group Configuration 135
Before you begin, make sure you know the catalog number for each
drive component, the Logix module and /or controller, and the servo
motor used in your motion control application.
To Next Page
Loading...
Need help?
General
