Chapter
1
Operation
Procedures
10. Test Feeding
• Test feeding
procedures
Drive button ON
'
Pump button ON
c.::::::l
~
(J
'
Paper feed button
ON
c.::::::l
'
Paper feed button
OFF
c.::::::l
'
Pump button OFF
c.::::::l
c0
'
Crawl ON/OFF
button ON
~
Operation Edition - 40
Feeding the sheets
of
paper, check and adjust each section.
1)
Correct the slewed
paper
fed from the
paper
feed section.
When the paper fed is slewed
on
the feeder board,
adjust
the
pull-out
roller
pressure
by
using
the
adjustment knob.
2)
Control the delivery
air
blower volume.
(1)
Control the delivery air blower volume
by
using the
delivery air blower control knob (1).
When the paper drops strongly [1]
or
weakly [2], control the delivery air blower volume to drop
the whole sheet equally
[3]
by using the delivery air blower control knob.
~.:,.:,.:.~
[2]
[
31
A WARNING
Push the
emergency
stop
button to
stop
the press before adjusting. Failure to follow
this instruction may result in a serious injury.
The
delivery air
blower
nozzle
can
be
opened
or
closed by turning the sleeve.
When
printing
on
smaller
size
paper,
close
the
unnecessary delivery air blower nozzle. Adjust the
opening and closing
of
the nozzle depending
on
the
delivery condition
of
the printed paper.
To Next Page
Loading...
Need help?
General
