Chapter
1 RYOBI PCS-F
8. Setting the Color and Conversion Curve Number for Each Unit
This system memory holds
31
kinds
of
conversion curve that converts the image area percentage
of
the plate to the ink
fountain key opening volume.
You can set the ink color used on each unit and the conversion curve number.
When inputting the data
of
the device for measuring image area
of
plate (DEMIA), ink volume setter,
or
ink volume
setter-
CIP3, the conversion curve number is used.
o8E
IDA
2
3
4
4
5
6 7
Dl
!!!s
D D D
D
D D
888
UNIT
K L M
= = =
0~
0offia
rn rn
rn
rn
rn
rn
rn
888
F 0 2
ALL
0 C
N
0 3
7
~.
J5
~D~B
SPJ
0 4
4t
~.
J2
II§Jo
1
C~A
utc
[
II
II
§)a
EJI
BU<
O[LocKJ
G
p
..
0
..
1.
Check that each button (H through M) on the ink fountain preset panel, ink fountain key 0 point reset button (E), and
lock button (G) are OFF.
2. Push the color/conversion curve number set button (K).
N0.1 UNIT N0.2 UNIT
[CYA.
3]
[MAG.
1]
3. Set the color on each unit by using the number input buttons (N). Set each color input by using the following button.
Move the cursor by using the
8 or 8 button.
[I]
.....
Black (BLK)
[1]
through
[2]
.....
Custom color
[]]
.....
Cyan (CY A)
[]]
.....
Magenta (MAG)
@]
.....
Yellow (YEL)
4. Set the conversion curve number for each unit.
For the relationship between the image area percentage
of
setting conversion curve number and the ink fountain key
opening volume, please refer to the table on the next page.
5. When completing the setting, push
the~
button.
The following message is indicated on the message display (P) and the color/conversion curve number set button
(K) lamp will go off.
I SETIING COMPLETE I
(Note) When setting the color, you cannot set the same color on any other unit.
If
doing this, the following message
is indicated on the message display (P).
WRONG COLOR SETIING. PRESS
ESC
KEY
Optional Accessories Edition - 16
To Next Page
Loading...
Need help?
General
