Chapter 1 RYOBI PCS-F
1-5 Maintenance after the Printing
lt.
Cleaning the Ink Fountain and Ink Fountain Roller I
«NOTICE»
Be sure to return the ink fountain
key
opening volume to "0" before cleaning the ink section.
( • Optional Accessories- 13)
Optional Accessories Edition -
22
£WARNING
Stop the
press
before cleaning. Failure to follow this instruction
may
result in a serious injury.
Remove the ink in the ink fountain.
Loosen the ink fountain fixing knobs and pull the ink fountain downwards.
Clean the side edges
of
the
ink
fountain roller,
both
sides
of
the
ink
fountain, and edge
of
the ink fountain key well.
«NOTICE»
1.
Do
not
use
any
powerful corrosive
acid
or
chlorine type cleaning
solution on the metal.
The
metal may corrode when the
acid
or
chlo-
rine reacts with the water.
Example
of
powerful corrosive chemicals:
Plate cleaner (powerful acid)
Blanket cleaner (chlorine type}
2.
If
the press will not
be
operated for 3 days
or
more, apply the
rust
preventive oil on the ink fountain roller after cleaning
it.
Also
if
the printing room environment is one with a high temperature
and
damp, the metal will easily corrode
and
rust. Therefore in this
environment when not using the press the following
day,
apply
the
rust preventive oil on the ink fountain roller after cleaning
it.
Remove the plate (1) and then clean each ink fountain key. Clean well so
that the
ink
does not remain
on
the edge
of
the
ink
fountain key.
Be
careful so as not to allow the ink to enter the inside (2).
If
there is any ink
on
it, it should be removed completely.
When changing the color, remove the plate (1) and clean the inside (2)
following the same procedures above.
To Next Page
Loading...
Need help?
General
