L
Replacing the Supplies
1.
Replacing the Blanket
After the blanket is used for a long time, the rubber will age causing the adhesiveness to be increased and the surface
of
the blanket to become slick and shiny. As a result, paper dust may adhere on the blanket surface, causing such picking
trouble as peeling and roughness
on
the paper to occur.
If
this problem becomes worse, paper may be
jammed
on
the
blanket cylinder
or
ink may not
be
transferred smoothly onto the blanket resulting in poor printing.
(Note) The blanket jam detector may actuate incorrectly depending on the blanket color. For more detailed information,
please ask your service technician.
0
o I
~
I
~·
ltW
1-
l
_L
7),_
~
/
a..,v<7
/_
Jl'
I/
~
ll-==-=--=
'j
"';,
:
Maintenance Edition - 38
«NOTICE»
1.
Before mounting the blanket, remove stains, etching solution,
and
water on the blanket cylinder surface. Make sure that the cylinder is
completely
dry,
and
then apply rust preventive
oil
over
the entire
surface
of
the blanket cylinder to protect
it.
2.
Be careful that the blanket recovery solution
and
other chemicals
do not adhere on the blanket cylinder surface.
If
they adhere on the
blanket cylinder surface, wipe them
off
with a cotton rag containing
water and cleaning solution immediately
and
apply rust preventive
oil over the entire surface
of
the blanket cylinder to protect
it.
(Recommended rust preventive oil list • Maintenance Edition -
7)
3.
Mount the aluminum bars (both the leading
and
tail edges) in the
blanket cylinder clamp holders exactly.
If
it is not mounted properly,
when running the press, the aluminum bars
may
release from the
holders and the blanket cylinder will be damaged.
£WARNING
Mount the blanket cylinder
gap
safety cover,
after
mounting the
blanket. Failure to follow this instruction
may
result in a serious
injury.
To Next Page
Loading...
