Chapter
5 Precautions
When
Doing Maintenance
A CAUTION
Adjustment and maintenance that should be done by the operator!
The adjustment of the ink and water roller pressure, adjustment of the feeder section, checking the air pump,
checking the dampening solution cooling/circulation device, and lubrication following the lubrication chart are the
adjustments and maintenance listed
in
the operation manual that should be done by the operator.
All
other adjustments and maintenance should
be
done by the service technician who has special knowledge and
technical expertise through training, so consult the dealer who you purchased the press from.
Turn off the power before cleaning the
static eliminator!
Turn off the power before cleaning the static eliminator
electrode.
Failure
to
follow
this
instruction may result
in
an
electric
shock.
Never replace any parts other than the
consumables!
Never replace any parts other than the consumables
shown
in
the
maintenance
edition
"Chapter
4
Replacing the Supplies"
in
this manual.
The replacement of all other parts should be done by
a service. technician who has special knowledge and
technical expertise through training, so consult the
dealer who you purchased the press from.
Failure
to
follow
this
instruction may result
in
an
injury.
Safety Operation Edition - 17
To Next Page
Loading...
Need help?
General
