5.6.1 Resetting the safety functions to the factory setting
Procedure
1. Go online.
2. Select "Commissioning".
3. Select "Backing up/reset".
4. Select "Safety parameters are reset".
5. Press the "Start" button.
6. Enter the password for the safety functions.
7. Conrm that the parameters have been saved (RAM to ROM).
8. Go oine.
9. Switch o the converter power supply.
10.Wait until all LEDs on the converter are dark.
11.Switch on the converter power supply again.
You have restored the safety functions in the converter to the factory settings.
❒
Exception: The password for the safety functions is not reset.
Password (Page258)
Procedure with an operator panel
1. Set p0010 = 30
Activate reset settings.
2. p9761 = …
Enter the password for the safety functions
3. Start the reset with p0970=5.
4. Wait until the converter sets p0970 = 0.
5. Set p0971=1.
6. Wait until the converter sets p0971 = 0.
Commissioning
5.6Restoring the factory setting
SINAMICS G120C Converters
154 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
To Next Page
Loading...
Need help?
General