A.1.7 Firmware version 4.7
Table A-7 New functions and function changes in Firmware4.7
Function SINAMICS
G120 G120D
1 Supporting the identication & maintenance datasets (I&M1…4) ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
2 Fall in pulse rate with increased drive power required by the motor
• The converter temporarily lowers the pulse frequency if required when the
motor is started up, and simultaneously increases the current limit.
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
3 S7 communication
• Direct data exchange between the converter and human-machine interface
(HMI).
• Increase in communication performance with the engineering tools and sup‐
port of the S7 routing
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
4 The basic functions of Safety Integrated are unrestrictedly available in all control
types with 1FK7 encoderless permanent-eld synchronous motors
- - - - - - ✓ -
5 Encoderless 1FK7 synchronous motors are supported
• Direct motor selection based on the article number with associated code
number
• It is not necessary to input individual motor data
- - - - - - ✓ -
6 Pulse input as source of setpoint value
• The converter calculates its speed setpoint from a sequence of pulses at the
digital input.
- - - - - ✓ - -
7 Dynamic IP address assignment (DHCP) and temporary device names for PROFI‐
NET
✓ ✓ ✓ - ✓ ✓ ✓ ✓
8 PROFIenergy device prole 2 and 3 ✓ ✓ ✓ - ✓ ✓ ✓ ✓
9 Uniform behavior for component replacement
• After a component is replaced, a converter with activated Safety Integrated
will report what type of component has been replaced using a unique code.
✓ ✓ - - ✓ ✓ ✓ ✓
10 Improved direct-component control in PM230
• Optimized eciency for pump and fan applications
- - ✓ - - - - -
11 Rounding down of BACnet and macros - - ✓ - - - - -
Appendix
A.1New and extended functions
SINAMICS G120C Converters
458 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
To Next Page
Loading...
Need help?
General