Troy-Bilt Horse - If Oil Leaks from Engine; Tightening Head Bolts on 7 HP Kohler with a Torque Wrench; Head Bolt Tightening Sequence for 7 HP Kohler Engine; Screwdriver Pcints to 6 HP Engine Oil Seal

'.
"
.',,,
. F .
. ".~
.......
-- ~
@--""y.
@
SPARK
Y' PLUGS
(photo 4/42) Screwdriver pcints to 6 HP eng/ne .
oil seEJ,l.
(Sketch 4/40) Head bolt tightening sequence
for
7 HP Kohler engine is in orders.hown (n this
sketch.
'.
(Ph-qto 4/41) TightenIng head bolts on 7HP
~ohle(, with a-torque wrench
'. ~,F OIL' LI:AKSFROM ENGINE
Engine oil leaks may be evidenced by oil
fQund i'n the bottom well of the motor mount,
.part number 1002. A leak could
be from a cover'
gasket; a ~ottom gasket, or from an engiheoil
seal sh'ewn in Photo 4/42.- Ofcourse, the engine'
. Ms tq be removed to'correct an oil leak from the
GOVer, 01' the seal. .
g en' the heacf b61ts of yo~r 7HP Kohler
engil'!e
to 180 - 240. inch-Ibs. in the seqL!ence
showri in Sketch 4/40. Simplyparti~lIly tighten
the bolts
as Numbered 1 through7 and go bacK
over the same sequence for final tightening.
Check head !;lolts for ti~htness after 8 to. 10
h6iJrs .of o~eratiC!)n 'on new engines and- on
engines that have had Ute head removed or a
., , new gasKet installed ..