GUID-D1617E87-9AE7-4350-854B-FBF0119DADC1
1. Display contrast
1. Activate the display contrast in the setting mode with the
button.
2. Adjust the display contrast with the arrow buttons.
The minimum contrast value is 80 and the maximum value is 120.
3.11 A-pillar display
The A-pillar display is located on the right-hand side front pillar.
The A-pillar display has two levels, a drive display and a driver's settings display.
The drive display gives information on the tractor's current status, for example
transmission or driving speed. The tractor settings and I/O tests are entered
through the driver's settings display. Additionally, the active fault codes are
shown on the display.
The display has a backlight to facilitate work in the dark.
3.11.1 A-pillar display control panel
The A-pillar display control panel is located on the dashboard.
You can use the control panel for changing between different views in the
display. In addition, some of the tractor settings and I/O tests are done using the
A-pillar display and control panel.
3. Operation
- 157 -
To Next Page
Loading...
Need help?
General
