Tyre Parameter value
650/65R42 MITAS AC65 923
650/65R42 MITAS SST 923
650/65R42 TRELLEBORG TM800 920
650/65R42 NOKIAN TRI2 923
650/75R38 MICHELIN MACHXBIB 917
650/75R38 MITAS SFT 922
650/75R38 TRELLEBORG TM900 929
650/75-38 NOKIAN FOR KING T 937
710/60R38 MICHELIN XEOBIB 852
710/60R42 MICHELIN XEOBIB 903
710/70R38 MICHELIN MACHXBIB 926
710/70R38 MITAS AC65 910
710/70R38 TRELLEBORG TM800 918
NOTE:
If the tractor has tyres not listed in the table, the tyre parameter can be calculated
with the following formula:
X = Y / (2π)
X = Tyre parameter
Y = Rolling circumference of the tyre
Example:
The rolling circumference of the tyre is 5420 mm.
X = 5420 / (2π) = 863
The tyre parameter for the tyre is 863.
4.8.2 Track widths
The track width is measured between the middle of the tyres. If needed, adjust
the track widths.
IMPORTANT: The maximum allowed width of the tractor is 2550 mm (if larger
width is not nationally allowed).
In many work applications, it is advisable to adjust the track widths so that the
track made by the front tyres is covered by the track made by the rear tyres.
When using narrow track widths for the rear axle, check that the lower links do
not touch the tyres. When required, lock the side regulators.
IMPORTANT: According to the EU directives the smallest allowed distance
between the side of the tyre and the mudguard is 40 mm and between the top of
the tyre to the mudguard is 60 mm.
4. Maintenance
- 334 -
To Next Page
Loading...
Need help?
General
