3.12.8 Using the lifting/lowering switch
When attaching implements, using the lifting/lowering switch gives you a full
control on the implement's movement. If necessary, you can stop the movement
immediately by releasing the switch.
The lifting/lowering switch functions even when the rear linkage is not activated.
GUID-F1E65AD2-AB04-45E2-A851-4BDD243C087B
1. Lifting/lowering switch
• To lift the linkage, press the symbol side of the lifting/lowering switch.
The longer the switch is pressed the faster the linkage lifts.
• To lower the linkage, press the side of the lifting/lowering switch opposite to
the symbol.
The longer the switch is pressed the faster the linkage lowers.
• To stop the movement of the linkage, release the lifting/lowering switch to the
centre position.
NOTE: The linkage has to be activated again every time the lifting/lowering
switch or the lifting/lowering push buttons have been used, if necessary.
3.12.9 Using the lifting/lowering push buttons
When using the lifting/lowering push buttons, the lifting/lowering continues for as
long as you keep pushing the respective button. The movement stops
immediately when releasing the button. Thus, you have steady control over the
linkage movements.
3. Operation
- 174 -
To Next Page
Loading...
Need help?
General
