Operating & Mounting instructions – 8 074 143.03/03 – Page 6
Changing the indication of the LED display:
1.) Switch to the 1st user level using the FUNC button.
2.) Use the UP/DOWN buttons to select the required display.
3.) Press the STR button to confirm the selection and to return to the display level.
Changing parameter settings on the 1st control level:
1.) Switch to the 1st control level using the FUNC button.
2.) Use the UP/DOWN buttons to select the required parameter.
3.) Press the FUNC button to switch to setting mode.
4.) Use the UP/DOWN buttons to enter the new setting.
5.) Press the STR button to confirm, save and return to 1st control level. Press the FUNC button to
return to the 1st control level without saving.
6.) Select the required display (e.g. d001) and press the FUNC button to confirm.
Changing parameter settings on the 2nd control level:
1.) Switch to the 1st control level using the FUNC button.
2.) Use the UP/DOWN buttons to select the required parameter group A, b, C, H or P.
3.) Press the FUNC button to enter the selected parameter group (2nd control level).
4.) Use the UP/DOWN buttons to select the required parameter.
5.) Press the FUNC button to switch to setting mode.
6.) Use the UP/DOWN buttons to enter the new setting.
7.) Press the STR button to confirm, save and return to 2nd control level. Press the FUNC botton to
return to 2nd control level without saving.
8.) Press the FUNC button to return to the 1st control level.
9.) Select the required display (e.g. d001) and press the STR button to confirm.
To Next Page
Loading...
General