3-11
INSP
ADJ
E
GENERAL
3. Measure:
● Spark plug gap a
Out of specification → Regap.
Spark plug gap:
0.9 ~ 1.0 mm (0.035 ~ 0.039 in)
4. Tighten:
● Spark plugs
NOTE:
● Before installing the spark plug, clean the
gasket surface and spark plug surface.
Also, it is suggested to apply a thin film of
anti-seize compound to the spark plug
threads to prevent thread seizure.
● If a torque wrench is not available, a good
estimate of the correct tightening torque
is to finger tighten a the spark plug and
then tighten it another 1/4 to 1/2 of a
turn b.
● Always use a new spark plug gasket.
T
R
.
.
Spark plug:
17.2 Nm (1.7 m • kg, 12.6 ft • lb)
Lubrication points
1. Apply:
● Water resistant grease
To Next Page
Loading...
Need help?
General
