P1036102-007 ZXP Series 7 Card Printer Service Manual 5
Theory of Operation
Card Movement During Printing
Step 6. For double-sided printing, the card is now moved back to the Card Flipper
where the card is turned over (rotated 180 degrees). The card is moved into
the Print Engine; and the card is printed (same as Step 5).
Step 7. If the Printer has a Laminator:
a. The card is moved through the Printer into the Laminator.
b. As the card passes through the Laminator, laminating film is applied to
the card, the top side or both sides depending on the Laminator.
c. The card (with the laminating film) then passes between a pair of heated
rollers, which seal the laminating film to the card.
d. The card is moved from the Laminator to the Card Exit, where it falls into
the Output Hopper attached to the left side of the Laminator.
Step 8. If the Printer does not have a Laminator; the card moves through the Printer,
where it falls into the Output Hopper attached to the left side of the Printer.
To Next Page
Loading...
Need help?
General
