Zebra ZXP 7 series Service Manual

P1036102-007 ZXP Series 7 Card Printer Service Manual 287
Replacement Procedures for the Laminator
Procedures: Card Exit Sensor Cable Assembly
Card Exit Sensor Cable Assembly
Step 1. Locate the Card Exit Sensor Cable Assembly.
Step 2. With a TORX T10 driver, remove the screw holding the Sensor in place;
indicated above.
Step 3. Carefully slide the Sensor and Cable down and out of the Laminator.

Zebra ZXP 7 series Specifications

General

Brand	Zebra
Model	ZXP 7 series
Category	Printer
Language	English