366 ZXP Series 7 Card Printer Service Manual P1036102-007
Cleaning
Cleaning the Laminator
Cleaning the Laminator
Note • To order a Laminator Cleaning Kit, visit www.zebra.com/supplies.
When to Clean
Cleaning requirements vary according to the environment. For a typical oce
environment, the recommended cleaning cycle is:
Step 1. Laminator Card Path cleaning should occur every 5,000 cards.
Step 2. Laminator Roller cleaning should occur every 5,000 cards.
Step 3. Laminator Oven (Heater Rollers) cleaning should occur every 20,000 cards.
Initiate the cleaning process
Note • To avoid a long wait while the heated rollers cool to 60oC, perform cleaning
before the rollers heat; i.e., when first turned on and the rollers are still cold.
Step 1. Press the MENU button on the Operator Control Panel (OCP). The OCP will
display the Main Menu.
Step 2. Scroll through the Main Menu, and select Advanced Settings. The OCP will
display the Advanced Settings Menu.
Step 3. Scroll through the Advanced Settings Menu, and select Clean Printer. The
OCP will display the Clean Printer Menu.
To Next Page
Loading...
Need help?
General
