370 ZXP Series 7 Card Printer Service Manual P1036102-007
Cleaning
Cleaning the Laminator
Clean the Laminator Oven (Heater Rollers)
Note • Recommend doing this at power up when the Laminator is already cold rather
than waiting for it to cool down to 140°F (60°C).
Step 1. From the Clean Printer Menu, select CLEAN LAM OVEN; and follow the OCP
instructions.
Step 2. Wait until the oven temperature falls below 140°F (60°C).
Step 3. Open the laminator covers.
Step 4. Remove the four thumb screws (circled below) holding the Heater Assembly
in place.
Step 5. Slide the Heater Assembly out of the Laminator (arrow below).
Caution • For the next step, you may have to wait until the Heater Assembly can be
handled comfortably.
Step 6. When ready, press Next.
Step 7. Prepare the Laminator Hot Roller Cleaning Card for use.
To Next Page
Loading...
Need help?
General
