64
DRIVING OPERATION
FH12N051 FH112N052 F_02_176a
STARTING THE ENGINE OF THE
TRACTOR
As a standard, the tractors are equipped
by glow plugs in the heads of rollers.
When starting the engine, it is
necessary to sit on the driver´s
seat.
1. Insert the key to the switchbox (“0”
position).
2. Depress the clutch pedal.
3. Shift the main gear shifting lever to
neutral position.
4. Shift the reversing lever to neutral po-
sition.
5. Make sure that all PTO switches on
the right column of the cabin are
switched off.
6. Turn the key to “I” position. A yellow
control will light up on the dashboard
signalising the proper igniting function.
7. Wait for the ignition control to turn off
(the time is dependent on the temper-
ature of the coolant).
If the ignition control merely
blinks instead of lighting up, there
is a disorder in the ignition sys-
tem (see ch.: Ignition system dis-
order signalization). The signal-
ised fault must be resolved in an
expert service garage.
8. Turn the key to the “II” position (start).
9. After starting the engine, release the
key immediately. Do not start for more
than 15 sec.
IGNITION SYSTEM DISORDERS
SIGNALIZATION
Ignition system disorders are signalized
by blinking of ignition control.
- If ignition control blinks at standstill
once per second, ignition in emergen-
cy system occurs just like at low tem-
peratures regardless of the tempera-
ture of coolant.
- If the ignition control blinks at standstill
twice per second, the ignition is put off
operation (does not work).
- If the ignition control blinks permanently
during the run of engine, there is a dis-
order of ignition control and ignition has
not been completed. The disorder must
be forthwith removed, because there is
the danger of battery depletion.
To Next Page
Loading...
Need help?
General