93
DRIVING OPERATION
F11N026 FH13N010 FH12N077
STOPPING THE TRACTOR – MANUAL
BRAKE
Stop the tractor slowly under standard
conditions. Shortly before stopping:
1. Depress the clutch pedal.
2. Shift the main gear shifting lever to
neutral position.
3. With every stopping, secure the trac-
tor against spontaneous dead start by
manual brake.
STOPPING THE ENGINE
After the work of tractor when the engine
was fully loaded, it is necessary to se-
cure its cooling.
1. Before stopping the engine, lower the
revolutions to 800 - 1000 revolutions
per minute and allow it to run for the
time of approximately 5 minutes.
2. Shift the lever of manual throttle to
STOP position.
3. The engine stops after turning the key
from “I” position to “0” position.
LEAVING THE TRACTOR
Before leaving the tractor with a safety
cabin, do not forget to remove the key
from the switch box in “0” position (in po-
sition I and II the key cannot be pulled
out).
Tractor must be secured against sponta-
neous start:
1. Engine off
2. Braked by manual brake
3. Wheels based by wedges.
Engaging a speed gear does
not secure the tractor from start
(clutch is switched off)
Lock the cabin.
To Next Page
Loading...
Need help?
General