Fault tracing 117
Tuning
Cannot enable the MicroFlex e190 because there is an error 10010:
• Check the drive enable input, if assigned, is connected and powered correctly.
Cannot enable the MicroFlex e190 because there is an error 10033 and/or
10035:
• Check the Safe Torque Off inputs on connector X2 are both connected and
powered correctly.
When the MicroFlex e190 is enabled the motor is unstable:
• Check that the load is firmly coupled to the motor.
• Use the Mint WorkBench Drive Setup Wizard to confirm that the correct motor
data has been entered.
• Use the Mint WorkBench Autotune Wizard to re-tune the motor.
• If the motor is still unstable, select the Mint WorkBench Autotune Wizard once
more. Click Options.... On the Bandwidth tab, move the Current and/or Position
and Speed Control sliders to a slower position to select a lower bandwidth. Click
OK to exit and then start the Autotune Wizard again.
Ethernet
Cannot connect to the drive:
• Check that the PC's Ethernet adapter has been correctly configured, as described
in
Configure the PC Ethernet adapter on page 94.
How do I configure my EtherCAT manager to operate with the MicroFlex e190?
• An EtherCAT ESI file (.xml) that describes the drive to the EtherCAT manager can
be uploaded from the controller using the Mint WorkBench EtherCAT tool.
To Next Page
Loading...
Need help?
General
