INTRODUCTION
G - 1
APPENDIX G - BCN PRESSURE TRANSMITTER
INTRODUCTION
This appendix covers the configuration and calibration functions of the BCN
Pressure Transmitter.
Refer to OPERATING PROCEDURES in Section 4 for information on the
following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field device.
Figure G-1 provides and overview of the configuration process. The follow-
ing table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure G-1. Configuration Flowchart (BCN)
T01616A
SELECT
DEVICE
TYPE
SELECT
MODE
SELECT
OUTPUT
TYPE
SELECT
OUTPUT
ACTION
ENTER
CONFIGURATION
ID TAG
ENTER
DAMPING
VALUE
ENTER
SECONDARY
UNITS
SELECT
ENGINEERING
UNITS
ENTER SECONDARY
LOWER/UPPER
RANGE VALUES
ENTER
LOWER/UPPER
RANGE VALUES
SELECT
INITIALIZE
MODE
STORE
CONFIGURATION
SELECT
FAIL
MODE
SELECT
TRANSMITTER
TYPE
ENTER
CHANNEL
NUMBER
ENTER 5
INPUT/OUTPUT
POINTS
DIGITAL
FUNCTION
GENERATOR
ABB FSK
ANALOG OTHERS
C
O
N
F
I
G
U
R
E
To Next Page
Loading...
Need help?
General
