ABB STT04 User Manual

INSTALLATION
DOWNLINK SOFTWARE
3 - 4
DOWNLINK SOFTWARE
The DownLink Software is a Windows

-based application that is used
to interface the STT04 terminal with a personal computer. The Down-
Link Software provides the STT04 terminal with the ability to:
Download firmware
upgrades to the STT04
When enhancements are made to the STT04 firmware, users can
access the latest revision via the internet and then download it to the
STT04 terminal from a personal computer.
Upload and download
configurations on a PC
Configurations can be saved from the STT04 terminal to a personal
computer for storage where they can be retrieved when needed.
System Requirements (Personal Computer)
Before attempting to install the DownLink Software on a personal
computer, be sure the PC has at least the minimum requirements
listed in Table 3-1.
Installing DownLink Software
1. Insert the CD.
2. Click Start and select Run.
3. Click in Open and type CD Drive letter:\setup and click OK.
4. Follow the installation prompts as they appear.
DownLink Software Practices
Table 3-1. System Requirements
System Attribute
Requirements
Minimum Recommended
Processor 486-based Pentium
®
-based
Hard disk space 8 Mb 16 Mb
Operating system and RAM memory
Windows 95 16 Mb 32 Mb
Windows NT

4.0 or greater 16 Mb 32 Mb
WARNING
When using the DownLink Software application, it is important
to name each STT04 terminal that will be used with a particular
personal computer. This is important to avoid database prob-
lems. Each STT04 terminal should have it’s own database that
will carry a name linking it to the corresponding STT04
terminal.

ABB STT04 Specifications

General

Brand	ABB
Model	STT04
Category	Transmitter
Language	English