ABB STT04 User Manual

INTRODUCTION
A - 1
APPENDIX A - SMART POSITIONER
INTRODUCTION
This appendix covers the configuration and calibration functions of
the Smart Positioner.
Refer to OPERATING PROCEDURES in Section 4 for information on
the following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Figure A-1 provides an overview of the configuration function.
The following table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure A-1. Configuration Flowchart (AVS)
T01615A
SELECT
DEVICE
TYPE
SELECT
MODE
SELECT
INPUT
CHARACTERIZATION
ENTER
CONFIGURATION
ID TAG
ENTER
DERIVATIVE
VALUE
ENTER
LOW/HIGH
LIMIT SIGNALS
SELECT
INPUT
SIGNAL
LOW FLOW
SHUTOFF
SELECT
DO3 ACTION
ENTER
DAMPING
VALUE
ENTER
LOWER/UPPER
RANGE VALUES
ENTER
PROPORTIONAL
GAIN (K )
P
ENTER
DERIVATION
ALARM
VALUE
STUCK ALARM
YES/NO
ENTER
INTEGRAL
VALUE (K )
I
STORE
CONFIGURATION
ENTER
LOW/HIGH
PRESSURE ALARMS
SELECT
PRESSURE
UNITS
SELECT
TRANSMITTER
TYPE
ENTER
CHANNEL
NUMBER
ENTER 11
INPUT/OUTPUT
POINTS
DIGITAL
FUNCTION
GENERATOR
ABB FSK ANALOG OTHERS
C
O
N
F
I
G
U
R
E

ABB STT04 Specifications

General

Brand	ABB
Model	STT04
Category	Transmitter
Language	English