Version 7.2 1025 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
configure voip > media voice >
telephony-events-max-duration
[NTEMaxDuration]
the DTMF signal duration on the other (TDM) side.
The range is -1 to 200,000,000 msec. The default is -1 (i.e., NTE
stops only upon detection of an End event).
62.9.4 RTP, RTCP and T.38 Parameters
The RTP, RTCP and T.38 parameters are described in the table below.
Table 62-37: RTP/RTCP and T.38 Parameters
Parameter Description
Dynamic Jitter Buffer Minimum
Delay
configure voip > media rtp-rtcp >
jitter-buffer-minimum-delay
[DJBufMinDelay]
Global parameter defining the minimum delay (in msec) of the
device's dynamic Jitter Buffer.
You can also configure the functionality per specific calls,
using IP Profiles (IpProfile_JitterBufMinDelay) or Tel Profiles
(TelProfile_JitterBufMinDelay). For a detailed description of
the parameter and for configuring the functionality, see
Configuring IP Profiles on page 393, or Configuring Tel
Profiles on page 428.
Note: If the functionality is configured for a specific profile, the
settings of the global parameter is ignored for calls associated
with the profile.
Dynamic Jitter Buffer Optimization
Factor
configure voip > media rtp-rtcp >
jitter-buffer-optimization-factor
[DJBufOptFactor]
Global parameter defining the Dynamic Jitter Buffer frame
error/delay optimization factor.
You can also configure the functionality per specific calls,
using IP Profiles (IpProfile_JitterBufOptFactor) or Tel Profiles
(TelProfile_JitterBufOptFactor). For a detailed description of
the parameter and for configuring the functionality, see
Configuring IP Profiles on page 393 or Configuring Tel Profiles
on page 428.
Note: If the functionality is configured for a specific profile, the
settings of the global parameter is ignored for calls associated
with the profile.
Analog Signal Transport Type
[AnalogSignalTransportType]
Determines the analog signal transport type.
 [0] Ignore Analog Signals = (Default) Ignore.
 [1] RFC 2833 Analog Signal Relay = Transfer hookflash
using RFC 2833.
Note: The parameter is applicable only to FXS and FXO
interfaces.
RTP Redundancy Depth
configure voip > media rtp-rtcp >
RTP-redundancy-depth
[RTPRedundancyDepth]
Global parameter that enables the device to generate RFC
2198 redundant packets. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_RTPRedundancyDepth). For a detailed description
of the parameter and for configuring this functionality in the IP
Profiles table, see ''Configuring IP Profiles'' on page 393.
Note: If this functionality is configured for a specific IP Profile,
the settings of this global parameter is ignored for calls
associated with the IP Profile.
To Next Page
Loading...
Need help?
General
