AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 587 Mediant 1000B Gateway & E-SBC
User's Manual 27. Analog Gateway
Parameter Description
General
Index
[EnableCallerId_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Module
[EnableCallerId_Module]
(Read-only) Displays the module number on which the port is located.
Port
[EnableCallerId_Port]
(Read-only) Displays the port number.
Port Type
[EnableCallerId_PortType]
(Read-only) Displays the port type (e.g., FXS).
Caller ID
Caller ID
caller-id
[EnableCallerId_IsEnabled]
Enables Caller ID generation (FXS) or detection (FXO) per port.
 [0] Disable
 [1] Enable
27.9 Configuring Call Waiting
The Call Waiting table lets you enable call waiting per FXS port. When call waiting is
enabled for a port and the device receives a call for the port, if the port is busy (i.e.,
currently in another call):
1. The device responds to the caller with a SIP 182 response (instead of a 486 busy).
2. The device plays a call waiting indication signal to the busy port.
3. When the device detects a hook-flash from the port, the device switches to the waiting
call.
4. The device plays a call waiting ringback tone to the calling party after a 182 response
is received.
Note:
• For ports that are not configured in the table, call waiting is according to the global
parameter, as described in ''Enabling Call Waiting'' on page 546.
• In the installed CPT file, you must include the "Call Waiting Ringback" (#17) tone
(heard by the calling party) and "Call Waiting" (#9) tone (heard by the called party,
for FXS interfaces only). For more information, see ''Call Progress Tones File'' on
page 739.
• For call waiting support, you must enable call hold for the calling and called
parties, as described in ''Enabling Call Waiting'' on page 546.
• For additional call waiting configuration, see ''Enabling Call Waiting'' on page 546.
• The section is applicable only to FXS interfaces.
The following procedure describes how to configure call waiting per port through the Web
interface. You can also configure it through ini file (CallWaitingPerPort) or CLI (configure
voip > gateway analog call-waiting).

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English