AudioCodes MediaPack MP-11 Series User Manual

User's Manual 898 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
The device adds the header "AUDIOCODES DEBUG RECORDING" to each debug
recording message, as shown below:
55.3.3 Debug Capturing on Physical VoIP Interfaces
You can capture traffic on the device's physical (Ethernet LAN) VoIP interfaces (Layer-2
VLAN tagged packets). The captured traffic can be saved in a PCAP-format file (suitable
for Wireshark) to a TFTP (default) or an FTP server. The generated PCAP file is in the
Extensible Record Format (ERF). The maximum file size of debug captures that can be
saved to the device is 20 MB.
To capture traffic on physical VoIP interfaces, use the following CLI commands:
 Starts physical VoIP debug capture:
# debug capture voip physical eth-lan
# debug capture voip physical start
 Captures packets continuously in a cyclical buffer (packets always captured until stop
command):
# debug capture VoIP physical cyclic buffer
 Retrieves latest capture (PCAP file) saved on a specified server:
# debug capture VoIP physical get_last_capture <TFTP/FTP
server IP address>
The file is saved to the device's memory (not flash) and erased after a device reset.
 Marks the captured file (useful for troubleshooting process):
# debug capture VoIP physical insert-pad
Before running this command, the debug capture must be started.
 Displays debug status and configured rules:
# debug capture VoIP physical show
 Specifies the destination (FTP, TFTP, or USB) where you want the PCAP file sent:
# debug capture VoIP physical target <ftp|tftp|usb>
 Stops the debug capture, creates a file named debug-capture-voip-<timestamp>.pcap,
and sends it to the TFTP or FTP server:
# debug capture voip physical stop <TFTP/FTP server IP
address>
If no IP address is defined, the capture is saved on the device for later retrieval.

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English