User's Manual 142 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
♦ For Media Service class, the default DiffServ value is set to 46
♦ For Control Service class, the default DiffServ value is set to 40
♦ For Gold Service class, the default DiffServ value is set to 26
♦ For Bronze Service class, the default DiffServ value is set to 10
12.5.3.4 VoIP Interfaces with Multiple Default Gateways
Below is a configuration example using default gateways per IP network interface. In this
example, the default gateway for OAMP is 192.168.0.1 and for Media and Control it is
200.200.85.1.
Table 12-12: Configured Default Gateway Example
Index
Type
Interface
Mode
IP Address
Prefix
Length
Default
Gateway
Device
Name
0 OAMP
IPv4
Manual
192.168.0.2 16 192.168.0.1 100 Mgmt
1
Media &
Control
IPv4
Manual
200.200.85.14 24 200.200.85.1 200 CntrlMedia
A separate Static Routes table lets you configure static routing rules. Configuring the
following static routing rules enables OAMP applications to access peers on subnet
17.17.0.0 through the gateway 192.168.10.1 (which is not the default gateway of the
interface), and Media & Control applications to access peers on subnet 171.79.39.0
through the gateway 200.200.85.10 (which is not the default gateway of the interface).
Table 12-13: Separate Static Routes Table Example
Destination Prefix Length Gateway Underlying Device
17.17.0.0 16 192.168.10.1 100
171.79.39.0 24 200.200.85.10 200
12.6 Configuring Static IP Routes
The Static Routes table lets you configure up to 30 static IP routing rules. Static routes let
you communicate with LAN networks that are not located behind the Default Gateway that
is specified for an IP network interface in the IP Interfaces table, from which the packets
are sent. Before sending an IP packet, the device searches the Static Routes table for an
entry that matches the requested destination host/network. If an entry is found, the device
sends the packet to the gateway that is configured for the static route. If no explicit entry is
found, the packet is sent to the Default Gateway as configured for the IP interface in the IP
Interfaces table.
You can view the status of configured static routes in the IP Routing Status table. This
table can be accessed by clicking the Static Routes Status Table link located at the
bottom of the Static Routes table (see ''Viewing Static Routes Status'' on page 836).
The following procedure describes how to configure static routes through the Web
interface. You can also configure it through ini file (StaticRouteTable) or CLI (configure
network > static).
To Next Page
Loading...
Need help?
General
