User's Manual 1122 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
Source/Destination Number.
Note: The parameter is applicable only to FXS interfaces.
62.10.9.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.
Table 62-63: Tone Detection Parameters
Parameter Description
DTMF-detector-enable
[DTMFDetectorEnable]
Enables the detection of DTMF signaling.
 [0] = Disable

= Enable (default)
MFR1-detector-enable
[MFR1DetectorEnable]
Enables the detection of MF-R1 signaling.
 [0] = Disable (default)

= Enable
[R1DetectionStandard] Determines the MF-R1 protocol used for detection.
 [0] = ITU (default)
 [1] = R1.5
Note: For the parameter to take effect, a device reset is required.
user-defined-tones-detector-
enable
[UserDefinedToneDetectorEnable]
Enables the detection of User Defined Tones signaling,
applicable for Special Information Tone (SIT) detection.
 [0] = Disable (default)
 [1] = Enable
sit-detector-enable
[SITDetectorEnable]
Enables SIT detection according to the ITU-T recommendation
E.180/Q.35.
 [0] = Disable (default)
 [1] = Enable
To disconnect IP-to-ISDN calls when a SIT tone is detected, the
following parameters must be configured:
 SITDetectorEnable = 1
 UserDefinedToneDetectorEnable = 1
 ISDNDisconnectOnBusyTone = 1 (applicable for Busy,
Reorder and SIT tones)
Another parameter for handling the SIT tone is SITQ850Cause,
which determines the Q.850 cause value specified in the SIP
Reason header that is included in a 4xx response when a SIT
tone is detected on an IP-to-Tel call.
To disconnect IP-to-CAS or IP-to-FXO calls when a SIT tone is
detected, the following parameters must be configured:
 SITDetectorEnable = 1
 UserDefinedToneDetectorEnable = 1
 DisconnectOnBusyTone = 1 (applicable fo
SIT tones)
Note:
 For the parameter to take effect, a device reset is required.
 The IP-to-ISDN call is disconnected on detection of a SIT
To Next Page
Loading...
Need help?
General
