AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 1171 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
[MaliciousSignatureDB]
MaliciousSignatureDB_Name, MaliciousSignatureDB_Pattern;
[ \MaliciousSignatureDB ]
For a description of the table, see ''Configuring Malicious
Signatures'' on page 701.
62.11.1 Supplementary Services
The SBC and CRP supplementary services parameters are described in the table below.
Table 62-72: SBC and CRP Supplementary Services Parameters
Parameter Description
Emergency Call Preemption Parameters
For more information on SBC emergency call preemption, ''Configuring Call Preemption for SBC
Emergency Calls'' on page 703.
SBC Preemption Mode
configure voip > sbc settings >
sbc-preemption-mode
[SBCPreemptionMode]
Enables SBC emergency call preemption.
 [0] Disable (default)
 [1] Enable
Emergency Message Condition
configure voip > sbc settings >
sbc-emerg-condition
[SBCEmergencyCondition]
Defines the index of the Message Condition rule in the Message
Conditions table that is used to identify emergency calls.
Note: The device applies the rule only after call classification
(but before inbound manipulation).
Emergency RTP DiffServ
configure voip > sbc settings >
sbc-emerg-rtp-diffserv
[SBCEmergencyRTPDiffServ]
Defines DiffServ bits sent in the RTP for SBC emergency calls.
The valid value is 0 to 63. The default is 46.
Emergency Signaling DiffServ
configure voip > sbc settings >
sbc-emerg-sig-diffserv
[SBCEmergencySignalingDiffServ]
Defines DiffServ bits sent in SIP signaling messages for SBC
emergency calls. This is included in the SIP Resource-Priority
header.
The valid value is 0 to 63. The default is 40.
62.12 IP Media Parameters
The IP media parameters are described in the table below.
Table 62-73: IP Media Parameters
Parameter Description
IPMedia Detectors
configure voip > media ipmedia >
ipm-detectors-enable
[EnableDSPIPMDetectors]
Enables the device's DSP detectors for detection features such
as AMD.
 [0] Disable (default)
 [1] Enable
Note:
 For the parameter to take effect, a device reset is required.

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English