AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 1115 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
62.10.9.1 Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Table 62-62: Tone Parameters
Parameter Description
SIP Hold Behavior
configure voip > sip-definition
settings > sip-hold-behavior
[SIPHoldBehavior]
Enables the device to handle incoming re-INVITE messages
with the "a=sendonly" att
ribute in the SDP, in the same way as if
an "a=inactive" is received in the SDP. When enabled, the
device plays a held tone to the Tel phone and responds with a
SIP 200 OK containing the "a=recvonly" attribute in the SDP.
 [0] Disable (default)
 [1] Enable
Note: The parameter is applicable only to analog interfaces.
Dial Tone Duration
configure voip > gateway dtmf-
supp-service dtmf-and-dialing > dt-
duration
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is played
(for
digital interfaces, to an ISDN terminal).
For digital interfaces: The parameter is applicable for overlap
dialing when ISDNInCallsBehavior is set to 65536. The dial tone
is played if the ISDN Setup message doesn't include the called
number. The valid range is 0 to 60. The default is 5.
For analog interfaces: FXS interfaces play the dial tone after the
phone is picked up (off-hook). FXO interfaces play the dial tone
after the port is seized in response to ringing (from PBX/PSTN).
The valid range is 0 to 60. The default time is 16.
Note for analog interfaces:
 During play of dial tone, the device waits for DTMF digits.
 The parameter is not applicable when Automatic Dialing is
enabled.
Stutter Tone Duration
configure voip > gateway dtmf-
supp-service supp-service-settings
> sttr-tone-duration
[StutterToneDuration]
Defines the duration (in msec) of the confirmation tone. A stutter
tone is played (instead of a regular dial tone) when a Message
Waiting Indication (MWI) is received. The stutter tone is
composed of a confirmation tone (Tone Type #8), which is
played for the defined duration (StutterToneDuration) followed
by a stutter dial tone (Tone Type #15). Both these tones are
defined in the CPT file.
The range is 1,000 to 60,000. The default is 2,000 (i.e., 2
seconds).
Note:
 The parameter is applicable only to FXS interfaces.
 If you want to configure the duration of the confirmation tone
to longer than 16 seconds, you must increase the value of
the parameter TimeForDialTone accordingly.
 The MWI tone overrides the call forwarding reminder tone.
For more information on MWI, see Message Waiting
Indication on page 547.
FXO AutoDial Play BusyTone
configure voip > gateway analog
fxo-setting > fxo-autodial-play-
bsytn
[FXOAutoDialPlayBusyTone]
Determines whether the device plays a busy / reorder tone to
the PSTN side if a Tel-to-IP call is rejected by a SIP error
response (4xx, 5xx or 6xx). If a SIP error response is received,
the device seizes the line (off-hook), and then plays a busy /
reorder tone to the PSTN side (for the duration defined by the

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English