AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 961 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
Gateway CDR Format Table
Gateway CDR Format
configure troubleshoot > cdr >
cdr-format gw-cdr-format
[GWCDRFormat]
The table defines CDR customization rules for Gateway calls.
The format of the ini file table parameter is:
[ GWCDRFormat ]
FORMAT GWCDRFormat_Index = GWCDRFormat_CDRType,
GWCDRFormat_FieldType, GWCDRFormat_Title,
GWCDRFormat_RadiusType, GWCDRFormat_RadiusID;
[ \GWCDRFormat ]
For a detailed description of the table, see Customizing CDRs for
Gateway Calls on page 861.
SBC CDR Format Table
SBC CDR Format Table
configure troubleshoot > cdr >
cdr-format sbc-cdr-format
[SBCCDRFormat]
The table defines CDR customization rules for SBC calls.
The format of the ini file table parameter is:
[ SBCCDRFormat ]
FORMAT SBCCDRFormat_Index = SBCCDRFormat_CDRType,
SBCCDRFormat_FieldType, SBCCDRFormat_Title,
SBCCDRFormat_RadiusType, SBCCDRFormat_RadiusID;
[ \SBCCDRFormat ]
For a detailed description of the table, see Customizing CDRs for
SBC Calls on page 865.
62.3.4 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 62-21: RAI Parameters
Parameter Description
[EnableRAI]
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.
 [0] = (Default) Disable
 [1] = Enable
Note: For the parameter to take effect, a device reset is required.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group table).
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English