4. Getting started
- The STATUS Led will go out.
- If the pow er cord should be unplugged ac cidentally while either the air inlet fa n or the air outlet fans are operating or the lamp
is on, allow the projector to cool do wn for 10 minutes with the power off. To light the lam p again, press the ON/O FF key. If the
lamp doesn’t light up immediately, press the ON/OFF key a few m inutes later. If it should still fail to light up, replac e the lamp.
- Cover the lens with the lens cap to protect it from dust.
Direct Power OFF
You can turn off this projector just by unplugging the power cord without pr essing the ON/OFF key.
• Don’t shut down the projector while the S TATUS Led is blinking after the lamp lights up because the lamp’s life m ay be short-
ened.
• Don’t turn the projector back on right after shutting it down because the lamp’s life may be shortened. (Wait about 10 minutes
before turning the projector back on.)
• Before shutting down the projector, be sure to close the menu s creen. If you shut down the projector without closing the menu,
the setting data of the me nu may not b e saved.
• Don’t shut down the projector w hile the filter is rolling.
4.5 Adjusting the position of the projected image
What can be done?
If the p rojected image is out of the screen after the adjustment, adjust t he projector pos ition or the lens position using the lens shift
function.
How to adjust
1. Press the OK key to display the LENS FOCUS/ LENS ZOOM menu.
Image 4-5
2. A djust with the ◄ or ► key to get a fine picture.
3. Adjust with the ▲ or ▼ key to get an approximate size.
4. Press the OK key.
The LE NS SHIFT menu appears.
Image 4-6
5. Press the ▲, ◄, ▼ or ► key to move the image position.
34
R5905597 PHXX SERIES 20/05/2014
To Next Page
Loading...
Need help?
General
Weight and Dimensions
