Setting Up Connection Using WPS Push Button Mode
0W20-02Y
If your wireless router supports WPS push button mode, you can easily set up a connection with a WPS button.
● How to operate the wireless router may vary on each device. See the instruction manuals for your
networking device for help.
1
Press .
2
Use / to select <Network Settings>, and press .
● If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press .
Logging on to the Machine(P. 34)
3
Select <Wireless LAN Settings>, and press .
● If the <Do you want to enable the wireless LAN?> message is displayed, select <Yes>, and press .
4
Read the message that is displayed, and press .
5
Select <WPS Push Button Mode>, and press .
6
Select <Yes>, and press .
➠ A PIN code is generated.
7
Press and hold the WPS button on the wireless router.
The button must be pressed within 2 minutes after performing step 6.
● Depending on the networking device, you may need to press and hold the button for 2 seconds or longer.
See the instruction manuals for your networking device for help.
Network
138
To Next Page
Loading...
Need help?
General