Special Processing
If the print results are not satisfactory, the following settings may improve the quality of the printouts.
Special Printing Mode A
Streaks may appear on printouts depending on the paper type or the environmental conditions. In this case,
setting this item may solve the problem. The improvement effect is weakest with <Mode 1> and strongest with
<Mode 4>.
Off
Mode 1
Mode 2
Mode 3
Mode 4
<Adjustment/Maintenance>
<Special Processing>
<Special Printing Mode
A>
● When printing from the computer, the setting in the printer driver takes precedence. When the
setting of [Graphics Mode] in the printer driver is changed to [UFR II Mode], the setting in the
operation panel takes precedence. Smudges Appear on Printouts(P. 378)
● This item cannot be set when <Barcode Adjustment Mode> is set to one of <Mode 1> to <Mode 3>.
Barcode Adjustment Mode(P. 316)
● Print density will be lighter when you select stronger improvement. It may also result in less sharp
edges and rougher details.
● If the problem cannot be solved in spite of this item having been set, set <Special Printing Mode D> to
<On>. Special Printing Mode D(P. 336)
Special Printing Mode U
Toner smudges and splatters may appear around printed characters, graphics, etc. depending on the paper
type or the environmental conditions (more specically when you print on heavy paper or use the machine in an
environment with low humidity). In this case, setting this item to <On> may solve the problem.
Off
On
<Adjustment/Maintenance>
<Special Processing>
<Special Printing Mode
U> <On>
Setting Menu List
334
To Next Page
Loading...
Need help?
General