Setting IPv6 Addresses
0W20-036
The IPv6 addresses of the machine can be conî ´gured via the Remote UI. Before
setting IPv6 addresses, check the IPv4 address settings ( Viewing IPv4
Settings(P. 161) ). You need to set the correct IPv4 settings to use IPv6 addresses.
The machine can use up to nine of the following IPv6 addresses:
Type Maximum
number
available
Description
Link-local address 1 An address that is only valid within a subnet or link and cannot be used to
communicate with devices beyond a router. A link-local address is automatically set
when the IPv6 function of the machine is enabled.
Manual address 1 An address that is entered manually. When using this address, specify the preî ´x
length and default router address.
Stateless address 6 An address that is generated automatically using the MAC address of the machine
and the network preî ´x that is advertised by the router. Stateless addresses are
discarded when the machine is restarted (or turned ON).
Stateful address 1 An address obtained from a DHCP server using DHCPv6.
1
Start the Remote UI and log on in System Manager Mode. Starting Remote
UI(P. 270)
2
Click [Settings/Registration].
3
Click [Network Settings] [TCP/IP Settings].
Network
157
To Next Page
Loading...
Need help?
General