Cisco CVR100W Administration Guide

Configuring VPN
Configuring Basic VPN Setup
Cisco CVR100W Wireless-N VPN Router Administration Guide 101
6
Configuring Basic VPN Setup
The CVR100W supports site-to-site VPN for a single gateway-to-gateway VPN
tunnel. In this configuration, the CVR100W creates a secure connection to another
VPN-enabled router. For example, you can configure the CVR100W at a branch site
to connect to the router at the corporate site, so that the branch site can securely
access the corporate network. You could have a router like the Cisco RV220W that
supports ten site-to-site VPN tunnels and have a CVR100W at each remote site to
provide secure connectivity.
Viewing Default VPN Settings
The basic VPN setup sets most parameters to defaults as proposed by the VPN
Consortium (VPNC), and assumes a pre-shared key, which greatly simplifies the
setup.
To view the default VPN settings on your CVR100W:
STEP 1 Choose VPN > Basic VPN Setup.
STEP 2 Click View Default Settings.
The following default VPN settings are displayed:
Basic VPN Setup Default Values for IKE
Exchange Mode Main
Local WAN (Internet)
ID
Local WAN (Internet) IP Address
Remote WAN
(Internet) ID
Remote WAN (Internet) IP Address
Encryption Algorithm AES-128
Authentication
Algorithm
SHA-1
Authentication
Method
Pre-Shared Key

Cisco CVR100W Specifications

General

Brand	Cisco
Model	CVR100W
Category	Network Router
Language	English