Cisco CVR100W Administration Guide

Configuring Network
Configuring LAN Settings
Cisco CVR100W Wireless-N VPN Router Administration Guide 43
3
Configuring LAN Settings
The default DHCP and TCP/IP settings work for most applications. You can assign
an IP address to each additional logical subnet on the CVR100W.
Configuring Basic LAN Settings
You can configure the CVR100W’s IP address and DHCP settings.
IPv4
To configure the default LAN IP address of the CVR100W:
STEP 1 Choose Networking > LAN > LAN Configuration.
STEP 2 In the IPv4 area, enter the following information:
STEP 3 Click Save.
After the CVR100W’s LAN IP address is changed, your PC is no longer connected
to the CVR100W.
STEP 4 To reconnect your PC to the CVR100W, do one of the following:
• If DHCP is configured on the CVR100W, release and renew your PC’s IP
address.
• Manually assign an IP address to your PC. The address must be on the same
subnet as the CVR100W. For example, if you change the CVR100W’s IP
address to 10.0.0.1, assign your PC an IP address in the range of 10.0.0.2 to
10.0.0.255.
VLAN Choose the VLAN number from the drop-down menu.
Local IP Address Enter the LAN IP address of the CVR100W.
Make sure the address is not in use by another device.
Subnet mask Choose the subnet mask for the new IP address from
the drop-down menu. The default subnet is
255.255.255.0.

Cisco CVR100W Specifications

General

Brand	Cisco
Model	CVR100W
Category	Network Router
Language	English