Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
continuity-check
91
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
continuity-check
To enable the transmission of continuity check messages (CCMs) for a maintenance association, use the
continuity-check command in Ethernet connectivity fault management (CFM) service configuration
mode. To disable message transmission, use the no form of this command.
continuity-check [interval time | loss-threshold threshold | static rmep]
no continuity-check [interval time | loss-threshold | static rmep]
Syntax Description
Command Default CCMs are not transmitted.
Command Modes Ethernet CFM service configuration (config-ecfm-srv)
Command History
Usage Guidelines The static MEP list configured using the mep mpid command is used to verify whether a MEP received
in a CCM is valid. If the MEP in the received CCM is not configured in the MEP list, an error CCM
received fault alarm is set.
interval (Optional) Configures the time period between message transmissions.
time (Optional) Time period between message transmissions. Valid values are as
follows:
• 100ms—100 milliseconds
• 10m—10 minutes
• 10s—10 seconds
• 1m—1 minute
• 1s—1 second
• 3.3ms—3.3 milliseconds
The values supported are platform dependent.
Note A 10ms interval is not currently supported.
loss-threshold (Optional) Sets the number of CCMs that should be missed before declaring
that a remote maintenance endpoint (MEP) is down.
threshold (Optional) Integer from 2 to 255. The default is 3.
static (Optional) Verifies that the MEP received in the CCM is valid.
rmep (Optional) MEP defined using the mep mpid command.
Release Modification
12.2(33)SXI2 This command was introduced.
12.2(33)SRE This command was integrated into Cisco IOS Release 12.2(33)SRE.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English