Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm ais link-status
108
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet cfm ais link-status
To enable Alarm Indication Signal (AIS) generation from a server maintenance endpoint (SMEP), use
the ethernet cfm ais link-status command in interface configuration mode. To disable AIS generation,
use the no form of this command.
ethernet cfm ais link-status [level level-id | period seconds]
no ethernet cfm ais link-status [level | period]
Syntax Description
Command Default AIS frames are not generated.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines This command has precedence over the ethernet cfm ais link-status global command issued in global
configuration mode.
Examples The following example shows how to configure AIS generation with a transmission period of
60 seconds:
Router# configure terminal
Router(config)# interface gigabitethernet 0/2
Router(config-if)# ethernet cfm ais link-status period 60
Related Commands
level (Optional) Indicates a maintenance domain level where the AIS will be sent.
level-id (Optional) Integer from 0 to 7 that identifies the maintenance level.
period (Optional) Configures the AIS transmission period generated by the SMEP
on the interface.
seconds (Optional) Integer value 1 or 60 that indicates the AIS transmission period
in seconds. The default is 60.
Release Modification
15.0(1)XA This command was introduced.
12.2(33)SRE This command was integrated into Cisco IOS Release 12.2(33)SRE.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
ethernet cfm ais
link-status global
Globally enables AIS generation and places the CLI in CFM SMEP AIS
configuration mode.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English