Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
mpls ip (global configuration)
245
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
mpls ip (global configuration)
To enable Muliprotocol Label Switching (MPLS) forwarding of IPv4 packets along normally routed
paths for the platform, use the mpls ip command in global configuration mode. To disable this feature,
use the no form of this command.
mpls ip
no mpls ip
Syntax Description This command has no arguments or keywords.
Defaults Label switching of IPv4 packets along normally routed paths is enabled for the platform.
Command Modes Global configuration
Command History Release Modification
12.0(10)ST This command was introduced.
12.0(14)ST This command was integrated into Cisco IOS Release 12.0(14)ST.
12.1(2)T This command was integrated into Cisco IOS Release 12.1(2)T.
12.1(8a)E This command was integrated into Cisco IOS Release 12.1(8a)E.
12.2(2)T This command was integrated into Cisco IOS Release 12.2(2)T.
12.2(4)T This command was integrated into Cisco IOS Release 12.2(4)T.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T.
12.0(21)ST This command was integrated into Cisco IOS Release 12.0(21)ST.
12.0(22)S This command was integrated into Cisco IOS Release 12.0(22)S.
12.0(23)S This command was integrated into Cisco IOS Release 12.0(23)S.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S
12.2(13)T This command was integrated into Cisco IOS Release 12.2(13)T.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB and
implemented on the Cisco 10000-PRE2 router.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
To Next Page
Loading...
Need help?
General
