EasyManuals Logo
Home>Cisco>Network Router>MWR 2941

Cisco MWR 2941 User Manual

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm mip level
131
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet cfm mip level
To provision a maintenance intermediate point (MIP) at a specified maintenance level on an interface,
use the ethernet cfm mip level command in interface configuration mode. To restore the default
configuration of the interface, use the no form of this command.
CFM IEEE 802.1ag Standard (CFM IEEE)
ethernet cfm mip level level-id [vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}]
no ethernet cfm mip level level-id [vlan {vlan-id | vlan-id-vlan-id | ,vlan-id-vlan-id}]
Syntax Description
Command Default No MIPs are configured.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines If you do not configure a VLAN, this command creates MIPs for all VLANs on an interface.
level-id Integer from 0 to 7 that specifies the maintenance levels at which MIPs can
be defined.
vlan (Optional) Indicates a VLAN for configuration.
vlan-id (Optional) Integer from 1 to 4094 that identifies the VLAN to be configured.
vlan-id-vlan-id (Optional) Integers from 1 to 4094 that define a valid range of VLANs to be
configured.
• The hyphen is required to separate the starting and ending VLAN ID
values that are used to define the range of VLAN IDs.
,vlan-id-vlan-id (Optional) Integers from 1 to 4094 that define a valid range of VLANs to be
configured.
• The comma is required to separate VLAN ranges.
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the Cisco pre-Standard Connectivity Fault
Management Draft 1 (CFM D1).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MWR 2941 and is the answer not in the manual?

Cisco MWR 2941 Specifications

General IconGeneral
BrandCisco
ModelMWR 2941
CategoryNetwork Router
LanguageEnglish

Related product manuals