Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ethernet cfm maintenance-points remote crosscheck
502
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show ethernet cfm maintenance-points remote crosscheck
To display information about remote maintenance points configured statically in a cross-check list, use
the show ethernet cfm maintenance-points remote crosscheck command in privileged EXEC mode.
show ethernet cfm maintenance-points remote crosscheck [mpid id | mac mac-address]
[domain domain-name] [vlan vlan-id]
Syntax Description
Command Default When no options are specified, maintenance point IDs (MPIDs), MAC addresses, domains, levels, and
VLANs for all maintenance points on the list are displayed.
Command Modes Privileged EXEC (#)
Command History
Examples Following is sample output from a show ethernet cfm maintenance-points remote crosscheck
command for maintenance points at maintenance level 4:
Router# show ethernet cfm maintenance-points remote crosscheck level 4
-------------------------------------------------------------------------------
MPID Level VLAN Mep-Up Remote Mac
-------------------------------------------------------------------------------
200 4 0 No aabb.cc00.0310
-------------------------------------------------------------------------------
mpid (Optional) Indicates that a maintenance domain is specified.
id (Optional) Integer from 0 to 8191 that identifies the maintenance domain.
mac (Optional) Indicates that a maintenance domain is specified.
mac-address (Optional) MAC address of the remote maintenance point, in the format
abcd.abcd.abcd.
domain (Optional) Indicates that a maintenance domain is specified.
domain-name (Optional) String of a maximum of 154 characters.
vlan (Optional) Indicates a VLAN for configuration.
vlan-id (Optional) Integer value of 1 to 4094 that identifies the VLAN.
Release Modification
12.2(33)SRA This command was introduced.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)SRD The evc keyword and evc-name argument were added on the Cisco 7600
Series Route Switch Processor 720 (RSP 720) and the Cisco 7600 Series
Supervisor Engine 720.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release does not support the evc parameter.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English